Description:
DS fixed jaw for multi-clamping system, Form B, serrated version.

Material:
Tool steel.

Version:
Hardened and ground, HRC 55 +/-2.

Note:
- Form A smooth version is for pre-machined workpieces.
- Form B serrated version is for raw parts.
- Form C offset/stepped version is for clamping with a small clamping edge.
- Lateral fastening holes are used for workpiece end stops.
- Two screw-on holes on the clamping surfaces permit seating ledges to optimise clamping depth.

Application:
- The DS fixed jaw is positioned on the clamping rail according to the clamping situation.
- Tightening the fastening screw creates a form-fit connection through the toothing.
- Fixed jaws with two fastening screws are preferred where higher machining forces are applied.

Advantages:
Lateral scales on the clamping rail and fixed jaw allow precise positioning of the fixed stop.

Supplied With:
- DS fixed jaw.
- Fastening screw.
- Slot key.

Dimensions / Variant Data:
- Suitable system width: 50 mm
- Form: B (Serrated)
- L: 44 mm
- B: 50 mm
- H: 25 mm
- L1: not applicable
- L2: 24 mm
- L3: 18 mm
- B1: 30 mm
- H1: 12.5 mm
- H2: not applicable
- D internal thread: M5
- D1 internal thread: M6
- D3: M10x30
- BN slot width: 5 mm