Description:
Compact hydraulic swing clamp operating as a traction cylinder.

Application:
For clamping fixtures where the clamping points must remain clear during workpiece removal or placement, including confined installation conditions.

Features:
- Combined swivel and stroke movement
- Actual clamping travel takes place by linear movement
- 90deg left-hand or right-hand swivel version
- Integrated overload protection
- Integrated metal wiper
- Compact design with collision-free workpiece accessibility
- Multiple housing and hydraulic connection variants

Operation:
- Actuation type: Single-Acting With Spring Return
- Clamp only after the swivel travel is completed
- Clamping arm must be restrained during installation to prevent damage to the ball guide

Material:
- Housing and piston: Steel
- Seal: NBR

Finish / Version:
- Housing: Black oxidised
- Piston: Hardened

Dimensions:
- Form: B
- Connection type: O-Ring Flange Connection
- Swivel direction: Left
- Piston diameter: 14 mm
- Travel: 8/6 mm
- B: 35 mm
- B2: 22 mm
- B3: 16 mm
- B4: 16 mm
- D: 10 mm
- G / Mounting thread: M27x1.5
- H: 110 mm
- H2: 91 mm
- H3: 70 mm
- H5: 11 mm
- H6: 8/6 mm
- H7: 8/10 mm
- H8: 12 mm
- H9: 11.5 mm
- H10: 7 mm
- H11: 22 mm
- L: 50 mm
- L3: 35 mm
- L8: -/58 mm

Technical Data:
- Maximum operating pressure: 350 bar
- Maximum permissible flow rate: 2.5 cm^3/s
- Oil requirement per stroke: 1.2 cm^3
- Swivel angle: 90deg

Accessories:
- K1863 clamping arm for compact hydraulic swing clamp

Supplied With:
- One screw or nut for clamping arm mounting
- M27x1.5 slotted round nut supplied only with the specified Form A screw-connection variants

Notes:
The permissible operating pressure depends on the clamping arm length. If the permissible volume flow may be exceeded, install a throttle check valve. For single-acting versions, the vent connection and sinter filter arrangement must be observed. The clamping arm is not supplied.